See every connection.
PDF/AI artwork stays vector-based. Remove unwanted lines or objects from this project copy; the original file is unchanged. Wire-exit markers and measurements are kept separately.
Wire exit measurement
Select a wire exit on the drawingClick a red wire exit to enter its measured amperes here.
Enter saves and advances. Shift+Enter saves and goes back. Skip leaves a measurement unchanged. Measured bundles stay together.
Click an exit to select it; drag its circle to reposition that exit. Shift adds to the selection. Hold Space and drag to pan, or use Hand. Ctrl + mouse wheel zooms. Measurements and assignments stay attached when an exit moves.
Power supply groups
Read. Check. Connect.
Suggestions use the matching artwork in the photo. Existing measurements are kept; all automatic assignments require review.
Drag a box over a handwritten number to enlarge it. Enter its amperes below manually, or run Read handwriting locally. Select wire exits before or after selecting a photo area. Enter its amperes below. Saved areas stay marked on the photo. Click a saved area or reading to automatically apply and save its current to the selected wire exits.
● Red: reading not connected ● Green: reading connected to a wire exit
Hold Space and drag to navigate the photo, or use Hand. Ctrl + mouse wheel zooms. Switch back to Select reading area to mark a measurement.
Selected photo reading
Measured groups
Each wire exit gets a row automatically. Amber suggestions appear first. Review them against the photo, correct their current or selected exits, then check Verified. For wires measured together, select their blank rows’ exits on the drawing and create one group. Reset clears a measurement and restores individual exit rows.